SPM Probes   1-Lever  

19 Series, Cantilever

Options
 
Series Resonant Frequency, kHz Spring Constant, N/m Length l ± 5,
µm		 Width w ± 3,
µm		 Thickness t ± 0.3,
µm
min typ max min typ max
19-th 50 80 110 0.17 0.6 1.7 125 35 1.0
Application

Cantilevers of the 19 series combine the high frequency and low spring constant, which makes them applicable to imaging soft and fragile surfaces at a relatively high speed in Tapping mode. The cantilevers may also be useful in LFM due to the high sensitivity to the lateral forces.

         Scans and application notes »
Probes
Features
less than
1 nm		 Features
1-10 nm		 Features
more than
10 nm		 EFM Materials
characte-
rising
HI'RES-C
1 nm		        
NEW!
SCD
7 nm		          
NSC/CSC
10 nm		        
LS
30 nm 		       
NSC/CSC
20 nm 		       
Pt        
Ti-Pt        
Cr-Au        
Calibrated
spring
constant		        
high resolution

Lateral resolution below 1 nm. For scanning small areas below 250 nm at 512 points.

1 nm radius
multiple diamond-like tips
hi'res-C
general purpose

Lateral resolution down to 5 nm for scan size below 1 μm.

NEW!
7 nm radius diamond tip
SCD

10 nm radius silicon tip
NSC/CSC
long scanning

Accurate resolution of surface features larger than 10 nm in diameter. Good for scan sizes above 3 μm at 512 points.

30 nm radius
LS

20 nm radius
Si3N4 - coated Si probes
NSC/CSC
Conductive

Probes with special coatings for conductive AFM modes.

25 nm radius tip
Pt coated

40 nm radius tip
Ti-Pt coated

50 nm radius tip
Cr-Au coated
Materials Characterizing

Solutions for quantitative analysis of materials properties.

Pre-measured
spring constant probes
-F Series
 
 

 

 

 

 
CONTACTS
MIKROMASCH

TOLL-FREE NUMBERS: USA: 1-866-SPMTIPS (776-8477)/ EU: + 8000-SPMTIPS (776-8477)
E-MAIL: INFO@MIKROMASCH.COM